Our saddlebags are universally designed to fit over or under the seat of most standard motorcycles.
![[Small Mount View]](images/bikemountsm.jpg)
The proper measurements that are required for our universally fitting bags are as follows:
- Measure side to side, from the back of the saddle, (riders position) to the arm of the directional signal, and compare the width measurements of the desired saddlebag. This measurement should be greater than the bag width.
- Measure from top to bottom. Use the bottom of the seat pad to the top of the exhaust pipe as a reference, and allow no less than 1" greater than the height of the desired bag for clearance.
- Saddlebag supports are strongly recommended, when available, for your make and model of motorcycle. (Ask your dealer.)
- Secure all 4 side tie down tabs with the supplied cable ties.
- Check saddlebags, fully loaded, to ensure that contact with the wheel or exhaust will NOT occur at any time.
- Saddlebags with exterior snap flaps should be mounted with the snaps facing to the front of the bike.
- Do not overload bags. Recommended maximum weight per side is 16 lbs.
- Keep bags clean using a damp cloth.
